How to install peel and stick tile over linoleum

Be careful not to pull or stretch the material or the pattern will not align. Working from top to bottom, pull the backing away as you evenly press the paper to the wall a few inches at a time.You can reposition if needed to ensure a vertical seam. Align the right side of the strip to your mark and lightly press the edge to the wall along the mark. Apply the paper to the top of the wall, allowing a bit of excess to overlap the ceiling which will be trimmed off later. Peel about 12вЂќ to 24вЂќ of the backing away from the top of the paper.This is the guide for your 1st strip, and it is very important for it to be a straight, vertical line. Using your level, draw a straight line down. Beginning on the left side of your wall, measure out from the corner the width of the paper and mark the wall lightly with a pencil.

Number the back of each strip as you go to keep your design in the correct order. Cut and trim product with a sharp razor knife changing the blade often to help maintain a smooth clean cut. Make sure to align any design from strip to strip prior to cutting and hanging each strip.

Pre-cut strips to wall height, allow an extra inch or two on top and bottom for trimming.

Allow newly painted surfaces to fully cure for a minimum of 4 weeks before applying this peel & stick wallpaper. Product will not adhere to unclean or textured surfaces. TOOLS REQUIREDДЇor best results, clean, dry and smooth all surfaces. Inspect each roll for any possible print defect and make sure rolls have the same run/lot number for exact color matching prior to cutting and hanging. Please read these instructions carefully before applying to a wall.

Candice Olson Modern Nature Second Edition.

Candice Olson Modern Artisan Second Edition.

Magnolia Home by Joanna Gaines Peel + Stick.

How to install peel and stick tile over linoleum